1/28/2024 0 Comments F4u 1d corsair plans and cutawayGlue ribs V-2, 3, 4, perpendicular to V-8 on V-b. Be sure to spend several evenings familiarizing yourself with construction.ĭraw centerlines on the wing, fin,and stab ribs to facilitate alignment during construction.ġ. Note those pieces that can be pinned flat during construction and those which must be built free-hand. Trial fit the parts while studying the plans and construction views. Separate the kit parts into the primary assembly groups - fuselage, wing, stab, and fin. Contact cement may be used to speed the attachment of the wing skins. Keep in mind that epoxy is heavy, so a light coat is highly advisable. Zap and Hot Stuff hold balsa parts and set very quickly (we recommend a small fillet of aliphatic resin glue over the cyanoacrylate joints), 5-minute epoxy may be used sparingly on ply parts. One's task is made much easier through the use of several of the new adhesives available. Due to the complex curves involved, much of the model must be built free-hand. Quote: "F4U-1D Corsair building instructions:Ĭonstruction of the corsair is not difficult but the model is complicated and will require attention to detail and alignment. This file includes scanned 2-page Royal kit plan, along with a bonus additional 3rd page showing all templates, as drawn by Luke Zollner. 61-1/2 in span, 669 sq in wing area, for.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |